PNEUMATIC ROLLER SEAT
45342
ASSEMBLY AND OPERATING INSTRUCTIONS
®
3491 Mission Oaks Blvd., Camarillo, CA 93011
Copyright © 2001 by Harbor Freight Tools®. All rights reserved. No portion of this
manual or any artwork contained herein may be reproduced in any shape or form
without the express written consent of Harbor Freight Tools.
For technical questions and replacement parts, please call 1-800-444-3353.
Revised Cover 12/04
Warning:The warnings, cautions, and instructions discussed in this instruc-
tion manual cannot cover all possible conditions and situations that may oc-
cur. It must be understood by the operator that common sense and caution
are factors which cannot be built into this product, but must be supplied by
the operator.
Unpacking
When unpacking, check to make sure all parts listed on Page 4 are included. If
any parts are missing or broken, please call Harbor Freight Tools at the number
on the cover of this manual.
Assembly
You will need a hammer and a crescent wrench to assemble this product.
1. Insert top of Lifting Pole [D] into the Hub [C] that has already been attached
to the Seat Cushion [A].
2. Now insert Seat Cushion and Lifting Pole assembly into the top of the Tool
Tray [E].
3. Check and tighten all fasteners as needed.
Operation/Maintenance
With its convenient tool tray, comfortable padded seat, and non-marking wheels,
the Pneumatic Roller Seat is essential for the multi-tasking craftperson.
To lower seat, sit on the Stool and pull up on the handle until you have lowered
the seat to the desired height (See Diagram I on Page 4). To raise seat, stand
next to the Stool and pull up on the handle. Release handle when seat has risen
to the desired height.
Do not let children play on or around the Roller Seat.
Do not stand on Roller Seat or use the tool tray to carry large amounts of weight.
Do not attempt to exceed the Roller Seat’s 300 lb capacity.
Once assembled, do not attempt to take this product apart.
Do not expose to heat. Parts of this product are under pressure.
REV 08/03
SKU 45342
Page 3
Parts List
Assembly Drawing
NO. DESCRIPTION
QTY.
1
A
B
C
D
E
F
G
H
I
Seat Cushion
Supporting Plate
Hub
Lifting Pole
Tool Tray
2-1/2” Wheel
Handle
Truss Head Bolt M6x20
Cap Nut
1
1
1
1
5
1
4
5
J
K
Lock Washer 10
Rivet 3x18
5
1
Diagram I, Lowering Seat
NOTE: Some parts are listed and shown for illustration purposes only and are not available
individually as replacement parts.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM
IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER
NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO
THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE
PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE
PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY
STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN
BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER
ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS
OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
SKU 45342
Page 4
|