Shown with fan and light kit (not included)
Hunter Accessory Table
Installation Instructions
47007-01 11/20/2007
Your new accessory Hunter table can be installed at one of three heights:
bar height
standard table height
lounge height
44.5”
(113 cm)
31.5”
(80 cm)
23”
(58 cm)
*shown with optional accessory light kit (not included)
Step 1
Note: Be sure to hold the power cord out of the
way of the bolt. Do not allow the power cord to
slip down the pole.
Bolt
1. Insert the bolt into the lower pole section and
secure with the cotter pin.
Cotter
Pin
Step 2
Table
2. Attach the upper adapter to the table with
six adapter screws with washers. read the
lower adapter into the upper adapter and
rotate one to two turns.
Hardware Needed:
Note: e lower adapter should not be
over-tightened. It should remain loose in
the upper adapter to properly attach to the
table.
Adapter Screw
64193-03-247
(x 6)
Hardware Needed:
Washer
64187-01-247
(x 6)
Lower
Adapter
Upper
Table
Adapter
Step 3-4
Table
3. Being careful not to damage the pole finish,
(with assistance from at least one other person)
place the hole in the center of the table over the
lower pole segment. Align the notch in the lower
adapter with the bolt. Rest the table on the bolt.
Lower Pole
Segment
4. With the notch resting on the bolt, rotate the
table clockwise to secure it to the pole.
Hunter Fan Company
2500 Frisco Avenue
Memphis, Tennessee 38114
© 2007 Hunter Fan Company
|