Model iHM60
Rechargeable
Mini Speaker
Disposing Of Internal Rechargeable Battery
A Consumer Guide to Product Safety
1. Make sure speaker is in open/expanded position.
2. Locate the three retaining screws inside of the lower speaker casing
and loosen each one with a small Phillips screw driver.
3. Remove the speaker baffle and circuit board to locate the battery on
the bottom of the lower speaker casing.
When used in the directed manner, this unit has been designed and manufactured to ensure your
personal safety. However, improper use can result in potential electrical shock or fire hazards. Please
read all safety and operating instructions carefully before installation and use, and keep these instructions
handy for future reference. Take special note of all warnings listed in these instructions and on the unit.
1. Water and Moisture – The unit should not be used near water. For example: near a bathtub,
washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement.
2. Ventilation – The unit should be situated so that its location or position does not interfere with
its proper ventilation. For example, it should not be situated on a bed, sofa, rug or similar surface
that may block ventilation openings. Also, it should not be placed in a built-in installation, such as
a bookcase or cabinet, which may impede the flow of air through the ventilation openings.
3. Heat – The unit should be situated away from heat sources such as radiators, heat registers,
stoves or other appliances (including amplifiers) that produce heat.
4. Clip the lead to the battery then dispose of battery in accordance with
your local regulations.
Maintenance
Place the unit on a level surface away from sources of direct sunlight or excessive heat.
Protect your furniture when placing your unit on a natural wood and lacquered finish. A cloth or other
protective material should be placed between it and the furniture.
4. Power Sources – The unit should be connected to a power supply only of the type described
in the operating instructions or as marked on the appliance.
•
•
5. Power-Cable Protection – Power supply cables should be routed so that they are not likely to
be walked on or pinched by items placed upon or against them. It is always best to have a clear
area from where the cable exits the unit to where it is plugged into an AC socket.
6. Cleaning – The unit should be cleaned only as recommended. See the Maintenance section of
this manual for cleaning instructions.
•
Clean your unit with a soft cloth moistened only with mild soap and water. Stronger cleaning agents, such
as Benzene, thinner or similar materials can damage the surface of the unit.
7. Objects and Liquid Entry – Care should be taken so that objects do not fall and liquids are not
spilled into any openings or vents located on the product.
8. Attachments – Do not use attachments not recommended by the product manufacturer.
9. Lightning and Power Surge Protection – Unplug the unit from the wall socket and disconnect
the antenna or cable system during a lightning storm or when it is left unattended and unused for
long periods of time. This will prevent damage to the product due to lightning and power-line
surges.
This product bears the selective sorting symbol for waste electrical and electronic
equipment (WEEE).
This means that this product must be handled pursuant to European Directive
2002/96/EC in order to be recycled or dismantled to minimize its impact on the
environment.
10. Overloading – Do not overload wall sockets, extension cords, or integral convenience receptacles
as this can result in a risk of fire or electric shock.
11. Damage Requiring Service – The unit should be serviced by qualified service personnel when:
A. the power supply cable or plug has been damaged.
B. objects have fallen into or liquid has been spilled into the enclosure.
For further information, please contact your local or regional authorities.
C. the unit has been exposed to rain.
D. the unit has been dropped or the enclosure damaged.
Electronic products not included in the selective sorting process are potentially
dangerous for the environment and human health due to the presence of hazardous
substances.
E. the unit exhibits a marked change in performance or does not operate normally.
12. Periods of Nonuse – If the unit is to be left unused for an extended period of time, such as a
month or longer, the power cable should be unplugged from the unit to prevent damage or
corrosion.
13. Servicing – The user should not attempt to service the unit beyond those methods described in
the user’s operating instructions. Service methods not covered in the operating instructions should
be referred to qualified service personnel.
IMPORTANT
Read before proceeding
If you have any question reagarding the operation or use of this product, please vist www.ihomeaudio.com
to view answers to frequently asked questions.
For Models That Use Lithium Batteries:
• Lithium batteries can explode or cause burns if disassembled, shorted, recharged, exposed to water, fire, or high temperatures &
not handled appropriately
• Do not place loose batteries in a pocket, purse, or other container containing metal objects, do not mix with used or other battery
types, or store with hazardous or combustible materials.
• Store in cool, dry, ventilated area.
Download from Www.Somanuals.com. All Manuals Search And DownPrliontaedd.in China
• Follow applicable laws and regulations for transport and disposal.
iHM60-030810-Intl Eng
Using the iHM60
To unlock and expand the speaker, grip the top and bottom
and give a small twist counter-clockwise. DO NOT pull hard
once open, as the built in spring will automatically extend the
speaker to its proper position
Press speaker down from the top and twist clockwise to lock in
place.
Connecting the iHM60
• Connect the mini-USB plug to the audio/charge input jack on
the speaker.
• Connect the stereo 3.5mm audio plug to the headphone jack
or line-out of any audio device.
• Slide the Power Switch of the speaker to the ON position.
The blue power light will come on.
Extend the Speaker
LED
USB Connection
Power Switch
USB Connection
• Press play on your audio device and adjust its volume to
listen to audio.
• If you wish to “daisychain” iHM60 speakers, connect the
3.5mm audio plug to the Line Out Jack on an iHM60 that is
already connected to an audio source (see above) and the
mini-USB plug to the audio input jack on another iHM60.
Note: the larger USB plug is used for charging only, not
for audio. Please refer to next section for charging
instructions.
Line-out
Jack
Charging the iHM60
The iHM60 is powered by a rechargeable battery in the
speaker. When the blue power light dims, or if you start to
notice sound distortion at higher volumes, it's time to recharge
the battery.
• Connect the larger USB plug to a powered USB port, such as
that on a computer. The light on the speaker will turn to red
while charging and turn blue when fully charged.
Note: you can continue to listen to the speaker while it is
charging
mobile phone
PSP
iPod
MP3/MP4
USB 2.0
Note: When not in use, turn speaker off to save battery power
PC
Laptop
Charging the iHM60
Connect To Audio Input Source
|