IHS1IHT3807DT
INSTRUCTION MANUAL
Important Safety Instructions
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufacturer’s
instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized
plug has two blades with one wider than the other. A grounding type plug has two blades
and a third grounding prong. The wide blade or the third prong is provided for your
safety. If the provided plug does not fit into your outlet, consult an electrician for replace-
ment of the obsolete outlet.
10. Protect the power cord from being walked on or pinched particularly at plugs, conve-
nience receptacles, and the point where they exit from the apparatus.
11. Only use attachments/accessories specified by the manufacturer.
12. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or
sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus
combination to avoid injury from tip-over.
13. Unplug this apparatus during lightning storms or when unused for long periods of
time.
14. Refer all servicing to qualified service personnel. Servicing is required when the appa-
ratus has been damaged in any way, such as power-supply cord or plug is damaged, liquid
has been spilled or objects have fallen into the apparatus, the apparatus has been exposed
continued
3
Important Safety Instructions
15. Only connect to the type of house-hold power supply as indicated in the operating
instructions and rating label.
16. Do not overload wall outlets or extension cords as this can result in a risk of fire or
electric shock.
17. Never push objects of any kind or spill liquid into this product through openings as
this could result in a risk of fire or electric shock.
18. When replacement parts are required, be sure the service technician has used replace-
ment parts specified by the manufacturer. Ask the service technician to perform safety
checks to ensure proper operation to avoid possible fire, electric shock, or other hazards.
19. If an outside antenna or cable system is connected to the product, be sure the antenna
or cable system is grounded so as to provide some protection against voltage surges and
built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70,
provides information with regard to proper grounding of the mast and supporting struc-
ture, grounding of the lead-in wire to an antenna connection to grounding electrodes, and
requirements for the grounding electrode.
20. The product should be mounted to a wall or ceiling only as recommended by the
manufacturer.
21. Where the AC plug or an appliance coupler is used as the disconnect device, the dis-
connect device shall remain readily operable.
4
Features
1
2
15
16
17
3
18
4
5
19
20
21
6
7
8
22
23
24
RESET
PLAY
9
10
11
25
26
12
27
28
13
14
5
Features
1
MENU Press the M button to enter the menu on an iPod.
2
FUNCTION Press the F button to switch between iPod, radio, and aux input con-
trol.
3
4
5
POWER Press the POWER button to turn the player on or off.
PLAY/PAUSE Press the PLAY/PAUSE button to play or pause an iPod.
EQ Press the EQ button to switch equalizer modes between Classic, Jazz, Rock,
Pop, Flat, SRS TruBass®, 3D.
6
Video Out Connect a video cable to the Video Output connection to send a video
signal from a Video iPod to a display (TV) with a Video Input. (video cable not
included)
7
8
9
S-Video Output The S-Video Output is an analog video output which allows the
video data to be split into two separate signals, brightness and color.
iPod When the included USB cord is connected, use this toggle switch to change
control between the unit (PLAY) and a computer (SYNC).
Mini-USB Use this Mini-USB port to connect the unit to a computer and syncs
your iPod directly from the player’s docking station.
10 AM Antenna Port Connection for the AM detachable antenna, which provides
flexibility and range when adjusting the AM reception.
11 FM Antenna Port Connection for the FM detachable and extendable antenna,
which provides flexibility and range when adjusting the FM reception.
12 AUX 2 Use the AUX 2 jack to connect an audio device to the player.
13 iPOD SHUFFLE Use the iPOD SHUFFLE port to connect a first generation iPod
shuffle to the player.
14 Headphone Jack Use the Headphone Jack to plug in a set of headphones (not
included).
15 Navigation Controls/SELECT Use the Navigation Controls to move through an
iPod menu system, or change the radio station. Press the center SELECT button
to select a song, photo, or video on your iPod, or when the power is off, use the
SELECT button to set the clock.
6
Features
16 TIMER Press the T button to set the player to turn on or off at a certain time.
17 SLEEP Press the S button have the player turn off after an elapsed period of time.
(5 to 90 minutes)
18 OPEN/CLOSE Press the OPEN/CLOSE button to extend and retract the motor-
ized iPod dock.
19 VOLUME Press the (+) button to increase the volume and the (-) button to de-
crease the volume.
20 iPod Motorized Docking Station Select the correct insert and connect your iPod,
iPod mini, or iPod nano.
21 LCD Display View the Time, PM Indicator, iPod Indicator, Aux Indicator and
Radio Frequency through this Liquid Crystal Display.
22 Light Control Switch to adjust the button lights between Hi, Medium, Low, and
Off.
23 Reset Press the RESET button using a paperclip or like object to restore factory
default settings on the unit.
24 Fuse (T1.6L/250V Fuse) If this fuse is blown, unplug the unit and replace it with
an equivalent type.
25 AUX 1 Use the AUX 1 (auxiliary) jack to connect an iPod shuffle or other audio
devices to the player.
26 Sub-Woofer Line Out Use the SW Line-out to connect the unit to an external
Subwoofer.
27 AC Cord (AC 120V / 60 Hz) The attached AC Cord provides power to the player.
28 Line-In Cord Use the Line-In Cord to connect the unit to external audio devices.
7
Peripherals
37
38
29
39
40
30
31
32
41
33
42
43
44
34
35
45
46
36
iPod Inserts
Model
#
3
4
5
6
7
8
9
iPod Capacity
4GB, and 6GB
iPod mini
20GB, and U2 Special Edition
40GB
iPod
20GB, 30GB, and U2 Special Edition
40GB
iPod with color display
iPod nano
1GB, 2GB, and 4GB
30GB
iPod with video
10 60GB, and 80GB
iPod nano (second generation)
11 2GB, 4GB, and 8GB
8
Peripherals Defined
29 REPEAT Press the REPEAT button to set an iPod to repeat one song, or all songs.
30 CHAPTER Press up on the CHAPTER button to increase the chapter number, or
press down on the CHAPTER button to decrease the chapter number.
31 ALBUM Press up or down on the ALBUM button to cycle through the iPod’s
albums.
32 AUX Press the AUX button to switch the player to AUX mode.
33 MENU Press the MENU button to enter the menu on an iPod.
34 CLOCK With the power off, press the CLOCK button to set the clock.
35 FL Press the FL buttons to adjust the volume of the player’s left speaker.
36 BASS Press the BASS buttons to adjust the bass level.
37 MUTE Press the MUTE button to decrease the volume entirely.
38 SLEEP/SNOOZE Press the SLEEP/SNOOZE button to set the sleep timer (5 - 90
minutes), or activate the snooze (5 minutes) after the alarm has gone off.
39 MEMORY Press the MEMORY buttons to cycle up and down through preset
radio stations.
40 PLAYLIST Press up on the PLAYLIST button to cycle up through the playlists on
an iPod, or press down on the PLAYLIST button to cycle down through the playl-
ists on an iPod.
41 MEM Press the MEM button and select a preset to save stations to the unit’s
memory.
42 SHUFFLE Press the SHUFFLE button to randomly play songs on an iPod.
43 TUN Press the TUN button to cycle up or down through AM or FM radio frequen-
cies.
44 DISPLAY Press the display button to cycle through the different items on the LCD
Display.
45 FR Press the FR buttons to adjust the volume of the player’s right speaker.
46 TREBLE Press the TREBLE buttons to adjust the treble level.
Buttons that are not defined in the Peripherals Defined section, are defined in the Features
Defined section.
9
Operations
Setting the Clock
a. With the player off, press the SELECT button in the Navigation Controls.
b. When the time begins to blink on the LCD Display, press the right button to cycle
up through the hour and press the left button to cycle up through the minute.
c. Wait 5 seconds, and the clock will be set with the specified time.
Setting the Timer
a. With the player off, press the TIMER button. Press the TIMER button again to
cycle through the different timer options (timer ON, timer OFF, ON, and OFF).
b. At the “timer on” or “timer off” functions (indicated by “ON” or “OFF” followed
by a time) press the right button to cycle up through the hour and press the left but-
ton to cycle up through the minute.
c. After the “timer on” and/or “timer off” functions are set, press the TIMER button
until the LCD Display reads “ON” by itself. (“OFF” by itself indicates that the
timer is deactivated)
d. Wait for 5 seconds and the timer functions will be set with the specified time.
Tuning the Radio
a. Press the FUNCTION button consecutively to select the FM or AM radio mode.
b. Tune to the desired station using the Navigation Controls on the unit or the TUN
button on the remote.
Saving Radio Stations to the Memory
a. Press the FUNCTION button consecutively to select the FM or AM radio mode.
b. Tune to the desired station using the Navigation Controls on the unit or the TUN
button on the remote.
c. Press the MENU button on the unit or the MEM button on the remote control.
d. Press the Navigation Controls or the IPOD FWD/HR. and IPOD REV/MIN buttons
to select a Preset to save the current station under.
e. After the preset has been selected press the MENU or MEM button. The current
radio frequency is now saved to the selected preset.
• There are 20 FM and 10 AM memory presets on this unit.
Operations that are not listed in the operations section, are explained in the Features Defined or
Peripherals Defined sections.
10
Operations
Viewing Video or Photos from your iPod on an External Device
a. Connect a composite video cable from the player’s video out jack to a composite
video input jack on a TV. You can also connect the player to a TV with an S-Video
cable.
b. Insert your iPod Video into the player and navigate to either the Photos or Videos
on the iPod.
c. On the iPod, select either Slideshow Settings in Photos or Video Settings in Videos.
d. On the iPod, set the TV Out setting to On.
e. Press the FUNCTION button until the player’s mode is set to IPOD, as indicated on
the LCD Display.
f. Make sure your external viewing device is set to the proper input. You will now be
able to control your iPod from the player’s control panel and remote, and view your
iPod on a video display.
Connecting other Digital Audio Devices
a. Connect an audio device to the AUX 1 or AUX 2 inputs.
b. Press the FUNCTION button to set the unit to AUX 1 or AUX 2 mode, as indicated
by the LCD Display.
c. The audio device will now play through the speakers of the player.
11
Service Information
Address 2116 Carr Street, St. Louis MO, 63106
Phone
Fax
1-314-621-2881
1-314-588-1805
Email
Website www.ilive.net
To download this Instruction Man- Para descargar este manual de Pour télécharger ce manuel
ual in English, Spanish, or French instrucción en inglés, español, o d’instruction en anglais, espagnol,
visit the Support section at
francés visite la sección de la ayu- ou le Français visitez la section de
iPod is a trademark of Apple Inc., registered in the U.S. and other countries. TruBass, SRS, and the SRS logo are trademarks of SRS Labs, Inc. All
©
other trademarks appearing herein are the property of their respective owners. All products subject to change without notice. 2007 DPI, Inc.
|